Adressing Modes of Microprocessor

Different Types of addressing mode
Different computer architectures vary greatly as to the number of addressing modes they provide in hardware. There are some benefits to eliminating complex addressing modes and using only one or a few simpler addressing modes, even though it requires a few extra instructions, and perhaps an extra register. It has proven[citation needed] much easier to design pipelined CPUs if the only addressing modes available are simple ones.

Most RISC machines have only about five simple addressing modes, while CISC machines such as the DEC VAX supermini have over a dozen addressing modes, some of which are quite complicated. The IBM System/360 mainframe had only three addressing modes; a few more have been added for the System/390.

When there are only a few addressing modes, the particular addressing mode required is usually encoded within the instruction code (e.g. IBM System/390, most RISC). But when there are lots of addressing modes, a specific field is often set aside in the instruction to specify the addressing mode. The DEC VAX allowed multiple memory operands for almost all instructions, and so reserved the first few bits of each operand specifier to indicate the addressing mode for that particular operand.

Even on a computer with many addressing modes, measurements of actual programs indicate that the simple addressing modes listed below account for some 90% or more of all addressing modes used. Since most such measurements are based on code generated from high-level languages by compilers, this reflects to some extent the limitations of the compilers being used.